Elite R800D Manual do Utilizador descarregar pdf (Página 11)

Elite Learning Universal Remote Control – R800D

Ver. 1.1 www.elitescreens.com / [email protected] / Page 11 of 23

Remark:

1. To return to beginning status, press the EXIT key or the device key (e.g. TV, or VCR…)

2. You must point your remote control to the device that you want to control during when you test the keys.

3. The keys of OK, EXIT only used to set-up your new remote control during set up. You can’t

control your device as normal menu function at this moment until you quit from set up.

4. If the device is locked, you must first unlock the device then setting up.

☆2: Set-up by Auto Search (suitable for TV,DVD,VCR,AUX1, AUX2,SAT)

If the set-up by brand and code failed or you cannot find the brand name in your remote control screen, you may

use the Auto Search to find the correct code to operate your device.

1. Turn on the device (e.g. television) you would like to operate. If it is a VCR, Please insert a tape.

2. Press the SET key on your new remote control for more than 3 seconds, then release it.

3. the CODE SETUP will shown in the LCD menu, and press the OK key.

4. The screen shows the DEV SEARCH in the LCD menu, and press the OK key, then you press device key to

select your desired operation device(e.g. DVD) and poit the remote control to the device you choosed already,then

press the OK key to start the Auto Search.(you must point your remote control to your device at the moment)

5. See if the device reacts or not, once the device reacts, press any key to stop the search.

6. Test if most of keys work good or not. If most keys work not good enough, please step 4~5.

7. If you find one satisfied code please press the OK key to save it and LCD shows SUCCESS then show DEV

SEARCH. You can press device key (e.g. DVD) again to finish SET UP or use or to select other set up.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Sem comentários

Elite R800D Manual do Utilizador Página 11